Samuel Willhite We completed a dishwasher installation in Canton, OH this week. The customer reported their dishwasher don’t work. Upon arrival, we found the unit needed complete replacement rather than repair. The Problem The customer contacted us because their dishwasher don’t work. The existing unit had reached the end of its service life and required replacement. Diagnosis … Read more
A Samsung washer in Canton, OH started making a grinding noise and wouldn’t proceed with the cycle. The customer tried switching to rinse and spin, but it just made the same sound. We found a failed drain pump that needed replacement. The Problem The customer was washing a fairly small load of fabric when it … Read more
We responded to a service call in Canton, OH for an LG refrigerator where the ice maker was leaking water into the cube reservoir and sometimes wouldn’t make cubes. Our diagnosis revealed a faulty water valve assembly that was seeping water when it shouldn’t have been running. The Problem The customer reported that their LG … Read more
A GE dryer in Akron was taking longer to dry than it should, with the customer suspecting a lint clog between the lint tray area and where they could reach to vacuum out when removing the tubing off the back. Our diagnosis revealed the issue was indeed related to ventilation, requiring a thorough cleaning and … Read more
A GE washer in Minerva wasn’t operating despite powering on normally. The customer had already replaced the board and drain, but the machine still wouldn’t fill, wash, or spin. We found a failed LED lock and broken rubber snubber affecting the entire wash cycle. The Problem The customer reported that the board and drain had … Read more
We serviced a Maytag washer in Canton, OH that would fill with water but wouldn’t wash or agitate. The problem turned out to be a failed lid switch that prevented the wash cycle from starting properly. The Problem The customer reported their washer fills with water but will not wash or agitate. The machine would … Read more
A Samsung oven in Canton, OH wasn’t heating properly — the customer reported the oven temp was off approximately 50 degrees and took forever to preheat. Our diagnosis revealed a failed convection fan motor that wasn’t spinning at all. The Problem The homeowner noticed their Samsung oven temperature was consistently running about 50 degrees low. … Read more
A Maytag washer in Canton, OH was not spinning out of balance. Our technician found multiple components had failed, requiring replacement of the shifter, belt, rollers, and coil valves to restore proper operation. The Problem The customer reported their Maytag washer was not spinning out of balance. This prevented the washer from completing its cycle … Read more
A Whirlpool dishwasher in New Philadelphia wouldn’t wash, leaving the homeowner with dirty dishes piling up. During our service call, we discovered the door latch had failed, preventing the wash cycle from starting properly. The Problem The customer reported their dishwasher won’t wash. When we arrived, the unit appeared to receive power but wouldn’t begin … Read more
A Frigidaire oven in Uniontown wasn’t holding consistent temperatures and had a burned-out light bulb the owners couldn’t find a replacement for. We diagnosed a faulty control board that was causing the temperature regulation issues and installed both a new control board and the correct replacement bulb. The Problem The customer reported that the oven … Read more