A Whirlpool washer in Canton was making loud bumping noise when spinning. We diagnosed worn tub support pads and installed new teflon pads to restore quiet operation. The Problem The customer reported their washer making loud bumping noise when spinning. This type of noise typically indicates worn suspension components or tub support issues that develop … Read more
A Kenmore dryer on Beauparc Drive in Akron wasn’t producing any heat. Another servicer had replaced the thermostat a month previously, but left a loosened connection which caused the thermostat to overheat and fail again. The Problem The customer reported no heat from their Kenmore dryer. This was particularly frustrating since another repair company had … Read more
A Louisville homeowner called when their Estate washer was full of water and didn’t work at all. We found the lid switch had failed, leaving the washer stuck after filling with no wash, drain, or spin cycles. The Problem The customer reported their washer was full of water and doesn’t work at all. The machine … Read more
We completed a dryer repair in Massillon for a customer whose Whirlpool dryer wouldn’t start. The dryer will not display the Estimated Time Remaining for a cycle, therefore the dryer will not start. After diagnosis, we found the user interface board had failed and needed professional rebuilding. The Problem The dryer will not display the … Read more
We responded to a service call in Canton, OH for a Maytag dryer that would turn on and make noise but the drum wouldn’t turn. After diagnosing the unit, we found the motor had failed and the lint screen was shot, leading the customer to decline repair due to parts cost. The Problem The customer … Read more
The washer was making a loud noise during the spin cycle, which was resolved by replacing the bearings.
The washer was making a grinding noise during cycles, which was resolved by replacing the bearing housing assembly.
The washer stopped working mid-cycle, failing to spin or drain. A sock was found stuck in the drain pump, which was replaced.
The dryer wouldn’t start, so we replaced the thermal fuse and heating element, ensuring it runs efficiently again.
The washer wouldn’t complete its cycle due to a locked drain pump. Replacing the drain pump and drive belt resolved the issue.