Whirlpool Dishwasher Repair (Model DU930PWSQ0) – Akron, OH
The dishwasher was making a loud noise when turned on, which was resolved by removing debris from the wash pump.
The dishwasher was making a loud noise when turned on, which was resolved by removing debris from the wash pump.
A Massillon homeowner needed removal of their broken Whirlpool over-the-range microwave and installation of a new unit they had purchased. We handled the complete replacement and disposed of the old microwave properly. The Problem The customer contacted us for removal of their broken microwave (over range) and installation of a new microwave they had already … Read more
A Canton homeowner called when their Whirlpool dryer wasn’t getting gas. We diagnosed failed gas valve coil packs and replaced them to restore proper operation. The Problem The customer reported their dryer was not getting gas. The unit would run but produce no heat, leaving clothes damp after full cycles. Diagnosis We found the gas … Read more
A Whirlpool washer in Canton, OH was displaying an F5 error code approximately 4 minutes after starting. The customer suspected a door lock issue, but our diagnosis revealed a loose connection that was causing the problem. The Problem The customer reported that approximately 4 minutes after starting the washer, an F5 code would appear. They … Read more
We responded to a service call in Alliance, OH for a Whirlpool washer that wouldn’t start. When we arrived and tested the unit, we could not duplicate the problem the customer reported. The Problem The customer contacted us because their Whirlpool washer wouldn’t start. This is a common complaint that can have several causes ranging … Read more
A Whirlpool refrigerator in Alliance, OH was running lights and display but providing no cooling or motor operation. The interior light worked and all lights on display lit up when pressing any button, but the compressor wasn’t running. Our diagnosis revealed a failed high voltage board on the back of the unit. The Problem The … Read more
A Whirlpool washer in East Canton wasn’t completing its spin cycle reliably. The homeowner reported that it doesn’t always spin out, leaving clothes soaked at the end of wash cycles. Our diagnosis revealed worn internal drive components that needed replacement. The Problem The customer called because their Whirlpool washer doesn’t always spin out. This intermittent … Read more
A Whirlpool washer on 6th Street Northwest in Canton stopped filling with water and wouldn’t agitate. Our diagnosis revealed a failed water level sensor that prevented the machine from detecting proper fill levels and advancing through the wash cycle. The Problem The customer reported their Whirlpool 800 series washer went out — it does not … Read more
The oven displayed an F2 error and only the top coil worked, heating dangerously fast. Replacing the control board resolved the issue.
A Whirlpool washer in Minerva wouldn’t drain, leaving clothes soaking wet after cycles. The customer called reporting their LSQ9544KQ0 model had completely stopped draining water. Our diagnosis revealed a failed lid switch that was preventing normal wash and spin operations. The Problem The customer reported their Whirlpool washer won’t drain. The machine was unable to … Read more