A Maytag washer in Carrollton, OH wasn’t draining properly, leaving clothes soaked at the end of cycles. During our inspection, we discovered the transmission splines were worn, which caused the hub to strip. The Problem The customer reported that clothes are soaked when done. The washer was not draining the water out when it finished … Read more
We responded to a service call in Canton, OH for a commercial Whirlpool coin-op washer that wasn’t cycling well. Upon inspection, we discovered the balance ring had worked loose on the washer tub, causing the operational issues. The Problem The customer reported that the washer isn’t cycling well. This type of issue in commercial coin-operated … Read more
The washer failed to drain due to an F9 E1 error. Replacing the drain pump, pressure sensor, and control board resolved the issue.
The washer failed to drain due to a faulty lid switch, which was replaced to restore normal operation.
The washing machine wouldn’t start and just buzzed. Replacing the faulty capacitor on the motor resolved the issue.
The washer displayed an error code ‘drn’ indicating drainage issues. After replacing the drain pump, the washer is now functioning properly.
The washer displayed an F28 code due to a failed Motor Control Board, which was replaced to restore functionality.
The Electrolux washer displayed error codes 32 and 21, making a grinding noise and failing to drain. Replacing the drain pump resolved the issue.
The front load washer was leaking water through a seam and underneath during operation. Replacing the door boot resolved the issue.
We responded to a service call on Glamorgan Street in Alliance, OH for a Whirlpool washer that became unlevel and started banging during spin. The washer progressively got worse and now will not run at all — control light comes on, but machine does nothing. Our diagnosis revealed heavily worn shock absorbers triggering multiple error … Read more