A Whirlpool washer in Canton, OH was displaying an F5 error code approximately 4 minutes after starting. The customer suspected a door lock issue, but our diagnosis revealed a loose connection that was causing the problem. The Problem The customer reported that approximately 4 minutes after starting the washer, an F5 code would appear. They … Read more
We responded to a service call in Alliance, OH for a Whirlpool washer that wouldn’t start. When we arrived and tested the unit, we could not duplicate the problem the customer reported. The Problem The customer contacted us because their Whirlpool washer wouldn’t start. This is a common complaint that can have several causes ranging … Read more
A Whirlpool refrigerator in Alliance, OH was running lights and display but providing no cooling or motor operation. The interior light worked and all lights on display lit up when pressing any button, but the compressor wasn’t running. Our diagnosis revealed a failed high voltage board on the back of the unit. The Problem The … Read more
A Whirlpool washer in East Canton wasn’t completing its spin cycle reliably. The homeowner reported that it doesn’t always spin out, leaving clothes soaked at the end of wash cycles. Our diagnosis revealed worn internal drive components that needed replacement. The Problem The customer called because their Whirlpool washer doesn’t always spin out. This intermittent … Read more
A Whirlpool washer on 6th Street Northwest in Canton stopped filling with water and wouldn’t agitate. Our diagnosis revealed a failed water level sensor that prevented the machine from detecting proper fill levels and advancing through the wash cycle. The Problem The customer reported their Whirlpool 800 series washer went out — it does not … Read more
The oven displayed an F2 error and only the top coil worked, heating dangerously fast. Replacing the control board resolved the issue.
A Whirlpool washer in Minerva wouldn’t drain, leaving clothes soaking wet after cycles. The customer called reporting their LSQ9544KQ0 model had completely stopped draining water. Our diagnosis revealed a failed lid switch that was preventing normal wash and spin operations. The Problem The customer reported their Whirlpool washer won’t drain. The machine was unable to … Read more
A customer on Laurel Green Drive Northeast in North Canton called with a familiar problem — their Whirlpool refrigerator had stopped working again with the same control panel issue affecting the middle drawer. They’d already tried unplugging it for 10 minutes with no success. The Problem The refrigerator stopped working again last night. The customer … Read more
A Whirlpool washer in Homeworth developed a locked lid that wouldn’t unlock. Our diagnosis revealed significant damage to the control board that made repair impractical for this older unit. The Problem The customer reported that the lid is locked and won’t unlock. This prevented normal operation of the washer, leaving laundry stranded inside the machine. … Read more
A Dover homeowner called about their Whirlpool washer making noise while operating. Our diagnosis revealed the bearings were going bad in the washer — a common failure point that creates grinding or rumbling sounds during the wash cycle. The Problem The customer reported their Whirlpool front-load washer was making noise while operating. This type of … Read more