A customer on West South Range Road in Alliance, OH called us about their Maytag washer not draining fully and clothes coming out soaking wet. After moving the unit upstairs, multiple fault codes had stored in the control system, pointing to various sensing errors. The Problem The customer reported their washer was not draining fully, … Read more
We responded to a service call in Mechanicstown for an NXR range that wasn’t heating properly. The customer reported the oven not heating well with a sporadic gas smell. Our diagnosis revealed a weak igniter that wasn’t drawing sufficient amperage to reliably open the gas valve. The Problem The customer complained that the oven was … Read more
A customer in Alliance contacted us for propane conversion on two dryers — a GE and an LG unit. They had the conversion kit for the LG and needed both units converted from natural gas to LP gas. The Problem The customer had a GE and LG dryer that needed converted to LP gas. They … Read more
A Kenmore washer in Canton, OH stopped spinning during its cycle. The spin cycle stopped, leaving clothes soaking wet. Our diagnosis revealed a motor failure that made replacement the better option. The Problem The customer reported that the spin cycle stopped working on their Kenmore washer. The machine would fill and agitate normally but wouldn’t … Read more
We responded to a service call in Canton, OH for an LG washer that was powering on but the control panel would go blank and power off when choosing a cycle. The customer had already contacted LG support who walked them through a reset, but the washer lost power again mid-cycle with the same repeat … Read more
The LG dryer was not heating despite turning on and spinning. A faulty high limit thermostat was replaced, restoring heat functionality.
The Maytag dryer wasn’t blowing air due to a cracked blower wheel. After replacing it, the dryer is now operating properly.
The washer was slow to drain and hesitant to cycle, leading to a clogged pump issue. The repair involved replacing the shift actuator and cleaning inlet screens.
The washer wasn’t turning on due to a tripped GFCI plug. After resetting, it ran smoothly, but a replacement is recommended.
The dishwasher was not cleaning properly due to clogged spray arms, which were cleaned and leveled for optimal performance.