Samsung Dishwasher Repair (Model DW7933LRASR/AA) – Alliance, OH
Heavy and Smart Auto lights were flashing due to an obstruction in the case brake water level sensor. Clearing the sensor and sump hose restored normal operation.
Heavy and Smart Auto lights were flashing due to an obstruction in the case brake water level sensor. Clearing the sensor and sump hose restored normal operation.
Washer displayed F5 and kept the lid locked. Replacing the failed lid switch restored normal operation.
The GE washer wasn’t filling and was throwing errors. Cleaning the water inlet screens and the drive belt restored normal operation.
Dryer wouldn’t start and later struggled with full loads due to a misinstalled idler pulley. We fitted the OEM pulley correctly and restored normal operation.
Washer would not drain or spin and made noise. Replaced failed drain pump to restore proper draining and spin.
A Kenmore dryer in Malvern, OH was producing heat inconsistently — working sometimes but mostly staying cold. Our diagnosis revealed a failed timer that would have cost more to repair than the unit was worth. The Problem The customer reported that heat works off and on, but mostly off. This intermittent heating made the dryer … Read more
A Maytag dishwasher in New Franklin, OH wasn’t closing properly when the customer called for service. The door won’t latch shut, making the unit completely unusable. Our diagnosis revealed a simple but critical mechanical failure that required immediate attention. The Problem The customer reported that the door won’t latch shut. This prevented the dishwasher from … Read more
A Frigidaire dishwasher on Brussel Road NE in Carrollton, Ohio wasn’t heating to dry dishes at the end of the cycle. When we opened it up, we found the heater connection had burnt off and needed a complete heater replacement plus harness repair. The Problem The dishwasher is not heating to dry the dishes at … Read more
A Whirlpool range in East Canton was displaying error code F2 E1 and experiencing control lockups that required disconnecting power to shut off the oven. Our diagnosis revealed a stuck cancel button on the user interface causing the malfunction. The Problem The customer reported error code F2 E1 with the oven not functioning properly. Controls … Read more
A customer on Weimer Drive Southeast in East Canton called about their Whirlpool washer with the door boot coming off. We found the door boot spring had failed, allowing the rubber seal to pull away from its proper position. The Problem The customer reported the door boot coming off. This is the rubber seal around … Read more