We received a service call for a Maytag washer on Werner Church Road Northeast in Canton, OH. The unit begins filling, then faults out with error code E2/F2 and will not advance past the fill cycle. Our diagnosis revealed a control board failure requiring replacement of expensive components. The Problem The customer reported that the … Read more
A GE microwave in Malvern, OH had completely lost power and wouldn’t respond to any controls. We discovered a wire with a bad connection where it connected to the thermal fuse — a factory defect that finally caused complete failure. The Problem The customer reported their microwave lost power entirely. No display, no response from … Read more
We completed a service call in Malvern, Ohio for a Whirlpool stove with a loose oven door handle. The customer reported the handle was coming loose from the door, and our inspection confirmed the mounting hardware had worked free over time. The Problem The customer contacted us because their oven door handle was loose. This … Read more
A Maytag washer and dryer in Paris, OH was giving the homeowner trouble with slow water intake on the washer and a suspected worn belt on the dryer. Our diagnosis confirmed both issues needed attention to get this laundry pair running properly again. The Problem The customer reported that water intake was slow on their … Read more
Refrigerator cooled sporadically due to a failing cold control thermostat. Replaced the thermostat and cooling is now consistent.
The Samsung dishwasher showed flashing Heavy and Smart Auto lights due to a blockage in the case brake water level sensor assembly. Clearing the case brake and sump hose restored normal operation.
A Frigidaire Dryer GLEQ2152ES0 in Alliance, OH was shutting down after a few minutes with flashing lights and an ‘Ad’ message. Replacing the heating element assembly, bearing kit, belt, and idler pulley restored normal operation.
The front-left burner stopped heating due to a corroded wire lead. We installed a new element and repaired the connection.
This Whirlpool dryer in Alliance wasn’t heating even though it ran. Replacing a blown high-limit fuse, cycling thermostat, and warped heater restored heat.
The dryer had no heat due to a failed heating element. Installing a new element restored proper cycling and heat.