A Maytag washer in Canton wasn’t spinning properly, though water and drain functions worked normally. The customer suspected it had gone off center. Our diagnosis revealed worn thrust bearings and a faulty drive belt causing the spin cycle failure. The Problem The customer reported their washer was not spinning. Water and drain seemed to function, … Read more
A customer in Alliance called about two appliances acting up: their Samsung washer would not spin out and the drum was constantly coming unbalanced, plus their Whirlpool dryer was not heating properly and clothes were taking forever to dry. We found one quick fix and one bigger repair need. The Problem The Samsung washer drum … Read more
A Samsung dryer at a home on South Seneca Avenue in Alliance, OH was turning on but wouldn’t tumble. We diagnosed a failed idler pulley and replaced it to restore normal operation. The Problem The customer reported that their dryer turns on but will not tumble. The unit would power up and run through cycles, … Read more
We responded to a service call in Paris, OH for a Frigidaire dishwasher with wash, clean, and sanitize lights blinking simultaneously and refusing to start. When we arrived for the scheduled appointment, the unit was operating correctly. The Problem The customer reported that the wash, clean, and sanitize lights were blinking simultaneously, and the dishwasher … Read more
A Salem homeowner called about their Frigidaire dishwasher not draining properly. We found multiple issues blocking drainage and completed the necessary repairs to restore proper operation. The Problem The customer reported their dishwasher not draining. Water was remaining in the bottom of the unit after wash cycles completed. Diagnosis Our inspection revealed the garbage disposal … Read more
A Magic Chef washer in Carrollton was overflowing due to a damaged pressure sensor hose. The hose had been eaten by mice, causing the water level sensor to malfunction and allow the tub to overfill. The Problem The customer reported that their washer would overflow. Upon inspection, we discovered the hose leading to the pressure … Read more
A KitchenAid refrigerator in North Canton was forming ice under the bottom freezer drawers that melted and dripped water onto the kitchen floor. The homeowner had to chip out the ice about once a week to prevent the water damage. We found a blocked drain line causing the moisture buildup. The Problem Ice forms under … Read more
A GE washer in Sherrodsville wasn’t cycling properly, so we headed out to diagnose the issue. What we found was a combination of a dirty cold water screen and a transmission leaking oil. The Problem The customer reported their GE washer was not cycling properly. The machine wasn’t completing its wash cycles as expected. Diagnosis … Read more
A Whirlpool washer in Bolivar was causing serious problems for the homeowner. The load was always out of balance and the washer would walk across the floor making loud banging noises. When we opened it up, we found the spin basket hub and wash plate had failed. The Problem The customer reported that their washer … Read more
We completed an over-the-range microwave installation for a customer in Alliance, Ohio. The customer needed a new microwave installed, and we handled the complete installation process. Everything tested out properly after installation. The Problem The customer contacted us to install a new over-the-range microwave. This was a straightforward installation job requiring professional setup. Diagnosis This … Read more