Louisville Appliance Repair recently completed a service call on Oakvale Street Southwest in Canton, OH for a customer whose Amana refrigerator model ARB2517C had stopped running despite having power. The customer suspected a faulty compressor, but when Samuel arrived for the in-home visit, the issue turned out to have a much simpler cause. No parts … Read more
When a Massillon, OH homeowner on Spindle St NW noticed their Maytag dishwasher leaking, they called Louisville Appliance Repair for an in-home evaluation. Samuel visited the address, tightened the hose connection to the water valve, and later confirmed on a follow-up visit that no active leak was present. With the customer planning to replace the … Read more
A Kenmore oven in North Canton had two problems: the left front burner wasn’t working and the broiler wouldn’t ignite despite the ignitor glowing. We found the issue was in the harness with surface igniter switches, which needed complete replacement. The Problem The customer reported issues with the left front burner, the small burner. The … Read more
A GE washer at a home on Carriage Lane in Alliance, OH was having trouble starting cycles correctly, jumping to the final rinse instead of beginning normally and failing to spin out. Samuel visited the home to diagnose the issue and found a loose tub nut. Tightening the nut resolved the problem, and the washer … Read more
The coin slot was jammed, preventing proper operation. After clearing the jam, the washer is now functioning correctly.
Water was leaking from the freezer, causing a mess on the floor. The issue was resolved by clearing a plugged defrost drain.
The dishwasher turned on but wouldn’t run. Replaced the drain pump and upgraded the pressure sensor to restore functionality.
The refrigerator was not cooling and the freezer failed to freeze. The issue was traced to low freon levels, making repair uneconomical.
The washer wouldn’t drain, preventing the rinse and spin cycles from completing. Replacing the lid switch resolved the issue.
The dryer was not turning on, but after repairing a cracked solder joint on the control board, it now functions properly.