A coin-operated Whirlpool dryer in North Canton was intermittently failing to start with the push button unless the lever was manually actuated. Our diagnosis revealed a worn push tab on the coin slide that wasn’t properly connecting with the timer mechanism. The Problem The customer reported that their coin-operated dryer intermittently will not start with … Read more
A Maytag dryer in Dellroy wasn’t heating despite spinning normally. We found faulty gas valve components that were preventing proper ignition and flame detection. The Problem The customer reported that the dryer spins fine but doesn’t heat. This is a common issue with gas dryers where the motor and drum operation remain normal, but the … Read more
A Whirlpool dryer on Maplegrove Street in Louisville wasn’t drying clothes and had no heat. We found the heating element had failed completely — burned out with visible breaks in the coil. The dryer cavity was also packed with hair and lint that restricted airflow through the system. The Problem The customer reported their dryer … Read more
A Speed Queen dryer in North Canton stopped working completely for a customer who confirmed it had power and was properly plugged in. The unit wouldn’t turn on at all, which led us to investigate the internal drive system where we found a broken belt wrapped around the motor pulley. The Problem The customer reported … Read more
The dryer was running but not heating. After replacing the heater coil valves, idler pulley, and drum support wheel, it started heating properly.
The dryer was not heating, indicating a recurring issue that needed attention. The timer was replaced, and a new terminal was installed on the wire.
The temperature dial on this GE dryer stopped functioning, causing inconvenience. Replacing the cracked timer knob restored its operation.
The dryer was not spinning properly, and the idler pulley was replaced to resolve the issue.
A Samsung dryer in North Canton, OH was making a loud noise when the customer hit start to begin the cycle. The homeowner suspected the belt had snapped, but the unit would power on without starting. Our diagnosis revealed a failed idler pulley — a common issue with Samsung dryers. The Problem When the customer … Read more
A Maytag Neptune dryer in Atwater hadn’t been heating for almost a year when we got the call. The customer had been dealing with cold air cycles, leaving clothes damp after full run times. Our diagnosis revealed a failed thermistor and faulty coil valves preventing the gas burner from igniting. The Problem The dryer wasn’t … Read more