Maytag Washer Repair (Model MVWX655DW1) – East Canton, OH
The Maytag washer was not functioning properly, making a humming sound after a brief operation. The issue was resolved by correcting the hose installation.
The Maytag washer was not functioning properly, making a humming sound after a brief operation. The issue was resolved by correcting the hose installation.
The oven was not preheating properly, which was fixed by replacing the bake element and the surface burner element.
The Maytag washer was malfunctioning, only spitting out water and then humming. After correcting the hose installation, it now operates properly.
The dryer was stuck running due to a faulty timer after a lightning strike. Replacing the timer resolved the issue.
We recently completed a dual appliance repair in East Canton for a customer dealing with two separate issues on the same service call. Their Whirlpool refrigerator was leaking water even though the water dispenser was turned off, and their oven couldn’t heat past 300 degrees and took over an hour to reach that temperature. The … Read more
The dryer was stuck running due to a faulty timer after a lightning strike. Replacing the timer resolved the issue.
The oven was not preheating properly, which was resolved by replacing the faulty bake element.
We received a service call from East Canton for a Bosch dishwasher that interrupted wash cycle when it would not drain. After the customer cleaned the filter, it drained and finished the run but now makes a noise when washing or rinsing. The Problem Dishwasher interrupted wash cycle when it would not drain. I cleaned … Read more
A Whirlpool washer in East Canton wasn’t completing its spin cycle reliably. The homeowner reported that it doesn’t always spin out, leaving clothes soaked at the end of wash cycles. Our diagnosis revealed worn internal drive components that needed replacement. The Problem The customer called because their Whirlpool washer doesn’t always spin out. This intermittent … Read more
A Whirlpool Duet Sport dryer in East Canton wasn’t spinning or heating when started — just clicking sounds. Our diagnosis revealed worn drum support components that needed replacement to restore normal operation. The Problem When starting the dryer it just clicks as if it starts but it does not spin or heat. The unit would … Read more