A customer on Freed Street in Minerva called about their GE washer experiencing power issues and water control problems. The unit would sometimes start and sometimes not, with water continuing to fill and not shutting off, creating an overflow risk. When we arrived, the washer was working fine currently. The Problem The customer reported that … Read more
We serviced a Midea washer on Woodland Avenue Northwest in Canton, OH that was leaking water at 11 minutes into the cycle. The culprit was a fabric softener sprayer plugged with calcium buildup. The Problem The customer reported their washer was leaking water at 11 minutes into the wash cycle. This timing pointed to an … Read more
A Whirlpool washer on W 1st St in Minerva was running through cycles but then stopping with a spinning noise without actually spinning. The unit required unplugging to reset, and we diagnosed a failed control board throwing an F3E1 error. The Problem The customer reported their unit runs through cycle, then stops. It makes spinning … Read more
Agitator wasn’t moving and the basket wouldn’t engage. Replacing the wash plate and spin hub restored proper agitation and spin.
Washer was stuck in drain and couldn’t change cycles. Replacing the pressure switch and running calibration restored normal operation.
The GE washer’s lid lock failed, preventing cycles from starting. Replacing the lid lock assembly restored normal operation.
This LG washer in Uniontown, OH showed an OE error and wouldn’t drain due to a failed drain pump. Replacing the pump restored proper draining and quieter cycles.
We serviced a Maytag A 8640 washer in North Canton that wouldn’t drain. Our diagnosis revealed a failed pump that needed replacement along with the drive belt. The Problem The customer reported that their washer will not drain. Water was remaining in the tub after wash cycles completed. Diagnosis Inspection of the wash machine revealed … Read more
A Kenmore washer in Canton, OH wouldn’t start when the customer pressed the controls. Our diagnostic revealed the temperature selector control had failed, but the customer decided to purchase a new washer instead of proceeding with the repair. The Problem The customer reported their Kenmore washer can’t start. No matter what settings they selected, the … Read more
A Maytag washer in Carrollton wasn’t completing its spin cycle, leaving clothes soaking wet after every wash. We found the drain pump had failed and replaced it with a factory part to restore normal operation. The Problem The customer reported that the spin cycle is not working, so clothes are super wet. This is a … Read more