Samuel Willhite A Frigidaire dryer in Minerva was acting erratically — it wouldn’t shut off and would only dry on the 15-minute timer setting while a set of lights kept blinking. We found the control board had failed and was sending incorrect signals throughout the system. The Problem The customer reported their dryer was hard to describe … Read more
A GE dryer in Canton wasn’t heating, leaving a homeowner with wet clothes and no way to finish laundry. Our technician Samuel found the issue was with the timer knob assembly, which needed to be replaced and reconnected in a new location to restore proper operation. The Problem The customer reported that the dryer doesn’t … Read more
A Canton homeowner called when their washer wouldn’t operate after washing a comforter. Our diagnostic revealed the machine was actually working correctly, though we discovered evidence of oil seepage from the transmission that could cause future problems. The Problem The customer reported their washer won’t operate after washing a comforter. This type of symptom often … Read more
We responded to an E09 error on an Admiral dishwasher in Louisville, OH. After diagnosing the unit, we found the pump and heater assembly had failed. The customer chose to replace the dishwasher rather than proceed with the repair. The Problem The customer contacted us about an E09 error displaying on their Admiral dishwasher. The … Read more
We received a service call in Louisville, OH for a Frigidaire washer with wash cycle issues. The customer reported that the wash cycle keeps stopping. After evaluation, the customer decided to replace the machine rather than proceed with repairs. The Problem The customer contacted us because their Frigidaire washer’s wash cycle keeps stopping. This intermittent … Read more
A commercial laundry facility on North Chapel Street in Louisville called about multiple washer and dryer issues — units not starting, intermittent heat problems, and water leaking from a soap dispenser. Our inspection revealed everything from loose wiring to socks jamming the drainage system. The Problem The customer reported dryer 13 wouldn’t start, washer 45 … Read more
A Maytag washer in Canton wasn’t spinning properly, though water and drain functions worked normally. The customer suspected it had gone off center. Our diagnosis revealed worn thrust bearings and a faulty drive belt causing the spin cycle failure. The Problem The customer reported their washer was not spinning. Water and drain seemed to function, … Read more
A customer in Alliance called about two appliances acting up: their Samsung washer would not spin out and the drum was constantly coming unbalanced, plus their Whirlpool dryer was not heating properly and clothes were taking forever to dry. We found one quick fix and one bigger repair need. The Problem The Samsung washer drum … Read more
A Samsung dryer at a home on South Seneca Avenue in Alliance, OH was turning on but wouldn’t tumble. We diagnosed a failed idler pulley and replaced it to restore normal operation. The Problem The customer reported that their dryer turns on but will not tumble. The unit would power up and run through cycles, … Read more
We responded to a service call in Paris, OH for a Frigidaire dishwasher with wash, clean, and sanitize lights blinking simultaneously and refusing to start. When we arrived for the scheduled appointment, the unit was operating correctly. The Problem The customer reported that the wash, clean, and sanitize lights were blinking simultaneously, and the dishwasher … Read more