Whirlpool Oven/Range Repair (Model WFG505M0BS3) – Alliance, OH
The stove emitted a gas smell when using the burners, indicating a gas line issue. Replacing the burner assemblies resolved the problem.
Job Reports
KitchenAid Oven Repair (Model KSGB900ESS0) – Malvern, OH
The oven was not functioning, and one gas burner was also out. After repairs, the oven and burner are now working properly.
Kenmore Oven/Stove Repair (Model 911.4368413) – East Sparta, OH
The dryer wasn’t heating, and several burners on the stove were malfunctioning. Both issues were resolved with new parts.
Admiral Oven Repair (Model FGGF3032MFD) – North Canton, OH
Two burners on the stove were not functioning, requiring repairs to restore full use.
GE Oven Repair (Model JBP67CM1BB) – Canton, OH
The electric oven failed to preheat due to a faulty bake element, which was replaced to restore functionality.
Maytag Oven Repair (Model 8114P734-6012-99-00) – North Canton, OH
The top oven wouldn’t heat up due to a failed control board, which was repaired since a new part was unavailable.
KitchenAid Oven/Stove Repair (Model KERS505XSS03) – Louisville, OH
The KitchenAid stove had a non-working burner, and the exhaust hood needed new light bulbs. Both issues were resolved during the service.
KitchenAid Oven Repair (Model KFGD500ESS04) – Canton, OH
The bottom oven wouldn’t heat, and the top was intermittent. Replacing the ignitors resolved the issue.
Maytag Washer Repair – Youngstown, OH (LAT9616AAE)
A Maytag washer on Denver Drive in Youngstown stopped mid-cycle and wouldn’t drain, with a hot plastic smell developing. Our diagnosis revealed a motor overheating issue on this LAT9616AAE model, but unfortunately the motor is no longer available for replacement. The Problem The washer will start a load and half-way into the cycle it stops … Read more
Maytag Washer Repair – Alliance, OH (MVWB835DW4)
A customer on West South Range Road in Alliance, OH called us about their Maytag washer not draining fully and clothes coming out soaking wet. After moving the unit upstairs, multiple fault codes had stored in the control system, pointing to various sensing errors. The Problem The customer reported their washer was not draining fully, … Read more