We recently completed a dual appliance repair at a home on Jewel Road in Carrollton, OH. The customer reported their Whirlpool dryer was not heating at all and their dishwasher does not run with water not entering. After diagnosis, we identified multiple component failures requiring parts replacement on both units. The Problem The homeowner contacted … Read more
A KitchenAid dishwasher on Dogwood Ave in Louisville, OH had a door that just falls open. We found failed door springs and bushings that couldn’t hold the weight of the door anymore. The Problem The customer reported that the door just falls open. This meant the dishwasher door wouldn’t stay closed during operation and would … Read more
A Bosch dishwasher on Milbourne Ave in East Liverpool, OH wasn’t staying closed properly. The door doesn’t latch, closes, but doesn’t stay closed. We found the dishwasher door latch was sprung and reset it on-site. The Problem The customer reported that the door doesn’t latch, closes, but doesn’t stay closed. This is a common issue … Read more
We received a call from a customer in Steubenville whose Samsung refrigerator had stopped cooling the refrigerator and freezer. When we arrived on Lexington Drive, we found a Samsung RF28HFEDTWW/AA displaying an 81C error code with clear evidence of a high-side refrigerant leak. The Problem The customer reported that their refrigerator had stopped cooling the … Read more
A Frigidaire dishwasher on Rolling Green Avenue in Massillon was leaking out of the door and the seal came loose. Our inspection revealed failed door seals that needed complete replacement to stop the water damage. The Problem The customer reported that it was leaking out of the door and then the seal came loose. Water … Read more
We received a service call in New Philadelphia for an Admiral washer that was not spinning clothes out. When we arrived for the scheduled appointment, we could not replicate the problem the customer described. The Problem The customer reported their Admiral washer was not spinning clothes out. This is typically a symptom that indicates issues … Read more
A Samsung front load washer in Minerva, OH wasn’t spinning properly according to the customer complaint. When we arrived for the scheduled service call, we ran the washer through its cycles but were unable to replicate the problem the customer described. The Problem The customer reported that the tub would not spin during wash cycles. … Read more
A customer in Canton called about their Whirlpool washer leaving clothes still wet after the spin cycle, though some settings were still working. Our diagnosis revealed a plugged cold water screen that was preventing the machine from completing its final rinse cycle. The Problem The customer reported that clothes were still wet after the spin … Read more
A Samsung oven in Massillon wouldn’t ignite, leaving the homeowner without a working cooking appliance. Our diagnosis revealed a failed hot surface ignitor — a common failure point on gas ovens that prevents the safety valve from opening to release gas for combustion. The Problem The customer reported that their oven will not ignite. This … Read more
A Whirlpool washer in Canal Fulton was showing a PF error and the door would lock on start but wouldn’t reopen. After checking everything over, we determined the unit appeared okay and recommended having an electrician address potential breaker issues. The Problem The customer reported that their Whirlpool washer door locks on start and won’t … Read more