A Whirlpool range in East Rochester, OH wasn’t heating in the oven while the surface burners worked fine. The customer suspected the bake heating element, but we found something different entirely. The Problem The customer reported that the oven stopped heating last night. Surface burners were working normally, and the display and clock functioned properly. … Read more
A customer in Alliance called about their Whirlpool refrigerator that was running but not cooling properly. The fan was running but the refrigerator was warm along with the freezer, acting like it was trying to kick on but just not getting there. We diagnosed a failed evaporator fan motor that needed replacement. The Problem The … Read more
A Whirlpool dryer on 40th Street Northeast in Canton, OH wasn’t responding when the customer tried to start it. The start/starter switch appeared non-functional, but our diagnosis revealed a deeper issue with the user interface that couldn’t be economically repaired. The Problem The customer reported that the start/starter switch was not working on their Whirlpool … Read more
A Whirlpool washer on 23rd Street Northwest in Canton wasn’t responding to commands and made loud noise when plugged in. We diagnosed an F3E1 error code pointing to the main control board failure. The Problem The customer reported that the control panel was not working and the washer made loud noise when plugged in. The … Read more
A Whirlpool washer on South Main Street in North Canton wasn’t completing its wash cycles. The machine would start but fail to finish, leaving customers with wet, unwashed clothes. Our diagnosis revealed a broken shifter that prevented the washer from moving through its cycle phases. The Problem The customer reported their Whirlpool washer starts but … Read more
We completed a service call in Malvern, Ohio for a Whirlpool stove with a loose oven door handle. The customer reported the handle was coming loose from the door, and our inspection confirmed the mounting hardware had worked free over time. The Problem The customer contacted us because their oven door handle was loose. This … Read more
Refrigerator cooled sporadically due to a failing cold control thermostat. Replaced the thermostat and cooling is now consistent.
This Whirlpool dryer in Alliance wasn’t heating even though it ran. Replacing a blown high-limit fuse, cycling thermostat, and warped heater restored heat.
The dryer had no heat due to a failed heating element. Installing a new element restored proper cycling and heat.
The cold control thermostat failed, causing intermittent cooling. Replacing the thermostat restored consistent temperature.