Samuel Willhite A Dometic refrigerator in Malvern wasn’t maintaining temperature properly. The customer reported it won’t get cold and slowly keeps warming up. Our diagnostic revealed failed ventilation fans on the rear of the unit. The Problem The customer called because their Dometic refrigerator won’t get cold and slowly keeps warming up. The unit was gradually losing … Read more
We responded to a service call in Minerva, OH for a Kenmore washer that was leaking water. Our technician found a small leak on the door boot during the inspection. The Problem The customer reported their Kenmore washer was leaking water. Water leaks can cause significant damage to flooring and surrounding areas if not addressed … Read more
A Samsung dryer in Uniontown was running but wouldn’t heat, with the customer suspecting the heating element needed replacement. Our diagnosis confirmed the heating element had failed, along with worn mechanical components that needed attention. The Problem The customer reported their Samsung dryer runs but won’t heat. They suspected the heat element needed replacement based … Read more
A Samsung dryer in Kent, OH wasn’t spinning when we arrived for service in September 2020. The drum would turn by hand but wouldn’t rotate during operation. Inspection revealed both the drive belt and idler pulley had failed. The Problem The customer reported their Samsung dryer was not spinning. The unit would start and run … Read more
A Samsung oven in Akron was starting to lose temperature during baking and not holding set temperature. We found the ignitor had failed again, but this repair was covered under warranty from our earlier work this year. The Problem The customer reported that their oven was starting to lose temperature as they baked and was … Read more
We serviced an Admiral washer in Massillon that wouldn’t complete cycles and displayed error code E48. The machine would start and then stop for no reason, sometimes before clothes got wet and other times when they were soaking wet but the spin cycle wouldn’t run. Our diagnosis revealed a failed door lock assembly causing the … Read more
We recently completed a washer repair on Woodlawn Avenue NW in Canton, OH. The customer’s brother reported that the Kenmore washer makes a noise, bounces and sometimes shuts off during the cycle, with multiple people confirming it wasn’t due to an unbalanced load. Our diagnosis revealed failed transmission and suspension components. The Problem According to … Read more
A North Canton homeowner called about their Frigidaire refrigerator freezer gasket that may need replaced, with the freezer causing a lot of ice and frost build up. Our inspection confirmed the freezer door gasket is worn out, but unfortunately the gasket is no longer available for this model. The Problem The freezer gasket may need … Read more
A Frigidaire refrigerator in North Canton wasn’t making ice, leaving the homeowner without this essential feature. When we arrived at the Angel Road Northwest location, our diagnosis revealed multiple ice system components had failed and needed replacement. The Problem The customer reported that the ice machine doesn’t work. The refrigerator was running normally otherwise, but … Read more
A customer in Alliance called about their LG washer that stopped mid cycle, with water lying in the bottom of the machine. The washer wouldn’t restart or run a spin cycle. Our diagnosis revealed a failed drain pump that needed replacement. The Problem The customer reported their washer stopped mid cycle, with water lying in … Read more