Samuel Willhite 
A Whirlpool front-load washer at a home on West Lincolnway in Minerva, OH was displaying F21 and SUD error codes and failing to drain properly. Samuel visited the home and found a sock obstructing the line before the drain pump. Once the sock was removed, the washer returned to normal operation. The Problem It’s is … Read more
When a household in Alliance, OH needed attention for two Samsung appliances, Samuel from Louisville Appliance Repair made a visit to Beechlawn Avenue Northeast to address the concerns. The customer reported that their Samsung washer door was leaking and that a door gasket needed to be installed on the refrigerator. Samuel cleaned hair and debris … Read more
A GE dryer at a home on Shillingford Cir NW in North Canton was taking noticeably longer than usual to finish loads, with a standard 45-minute cycle stretching to 60 or 80 minutes. Samuel visited the home on March 26, 2020, and found that cleaning the dryer vent resolved the issue. No parts were needed, … Read more
Louisville Appliance Repair recently completed a service call on Greenfield Ave SW in Canton, OH for a Whirlpool front-load washer, model WFW9400SW03. The customer reported that the unit would power on normally but shut off as soon as it was turned to start a cycle. Samuel visited the home to diagnose the issue and get … Read more
Louisville Appliance Repair recently completed an in-home service call on Ridge Road Northwest in Canton, OH, where a Frigidaire refrigerator, model FRY18S8KS3, had stopped working. Samuel visited the home and found that a tripped circuit breaker was the cause of the issue. After resetting the breaker, the refrigerator returned to normal operation, and the customer … Read more
A Whirlpool washer in Minerva was stopping in cycle randomly, leaving loads half-finished. Our diagnostic revealed the timer mechanism had failed, causing the unpredictable mid-cycle shutdowns that frustrated this customer. The Problem The customer reported their Whirlpool washer stops in cycle randomly. This meant wash loads would start normally but then halt unexpectedly at various … Read more
A Whirlpool dryer in Canton, OH stopped heating up between loads of clothes with no forewarning to the issue. The dryer would run, but was not heating up. We found the heating element had failed and needed replacement. The Problem The customer reported their dryer will run, but is not heating up. There was no … Read more
A Canton homeowner called about their Maytag washer that would start but wouldn’t actuate, with water stuck in the tub. Our diagnosis revealed a failed lid switch assembly — a common failure point that prevents the wash cycle from engaging properly. The Problem The customer reported that their washer starts but will not actuate, with … Read more
A customer in Bolivar called about their Whirlpool dryer with a stuck coin slide. They suspected a coin might be jammed in there, and they were right — we found the slide completely jammed and cleared the obstruction to get their dryer running again. The Problem The customer reported: “I did empty them so I … Read more
When a Port Washington, OH customer noticed their GE dryer model GTDX200EM0WW had power but would not start, Samuel headed out to Canal St to take a look. He found that the timer knob had cracked, preventing the dryer from being started. A replacement knob was shipped directly to the customer to get the machine … Read more