A Whirlpool dishwasher on Maplegrove Street in Louisville wouldn’t latch properly and refused to start. The customer was convinced the door latch had failed, but when I pulled the unit out to check the mechanism, I found the real problem was much simpler — a loose mounting screw had thrown off the door alignment. The … Read more
We responded to a Samsung range repair call on William Penn Avenue Northeast in Hartville, OH. The customer was getting a C-F0 error code when trying to start the oven — it wouldn’t ignite and threw the code about a minute after pressing start. What we found inside made this repair more complicated than expected. … Read more
We got a call from Linda Beadnell in Malvern about her GE refrigerator leaking. When we arrived at her East Mohawk Drive home, we found the defrost drain was completely plugged with ice buildup. The Problem Linda’s GE refrigerator was leaking water. The leak was coming from inside the unit, creating puddles that needed constant … Read more
A Whirlpool washer on Graham Drive in Louisville was only cycling to the wash but would not spin or rinse, staying stuck at those cycles. The customer had tried a factory reset which worked temporarily before the problem returned. Our diagnosis revealed a failing main control board throwing an F3E2 power error. The Problem The … Read more
A Maytag washer in Canton, OH was displaying F9E1 error code and draining water unexpectedly. The customer reported that it started draining the water out right before they left that morning, with the error code still flashing and the lid still locked. Our diagnosis revealed a failed drain harness causing the drainage malfunction. The Problem … Read more
A Whirlpool refrigerator on Northlawn Avenue NE in Louisville had a display that wouldn’t light up unless pushing buttons. We diagnosed the issue and replaced the main control board to restore normal operation. The Problem The customer reported that the display won’t light up unless pushing buttons. The refrigerator’s control panel remained dark during normal … Read more
A Canton homeowner called us about their Kenmore range overheating despite already replacing the temperature sensor. We found visible damage to the main control board and an F10 error code indicating the real culprit behind the persistent overheating issue. The Problem The customer reported their oven was overheating and running too hot. They had already … Read more
A Maytag dryer on Ohio Street in Alliance, OH was running but not drying clothes. We found the thermal fuse had blown, cutting off heat to the drum while allowing the motor to continue running. The Problem The customer reported their dryer runs but not drying. The unit would start and tumble clothes normally, but … Read more
A Whirlpool dryer on Smyth Avenue in Alliance, OH wouldn’t start — it powered on but wouldn’t spin. The customer had already diagnosed the issue and purchased a repair kit, knowing the belts were broken. The Problem The customer reported their dryer won’t start. It powers on but won’t spin, and they noted that belts … Read more
A Canton homeowner called about their Maytag washer that would start sensing the load and then the light would go to done. After replacing the lid lock twice without success, we diagnosed capacitor failure with F5E3 and F7E1 error codes. The Problem The customer reported that the washer starts sensing the load and then the … Read more