A Maytag Bravos MCT washer in Minerva, OH wasn’t spinning clothes out properly, leaving them dripping wet after cycles. We found the transmission hub on the basket had stripped out completely. Due to corrosion on the transmission shaft, this repair may be temporary. The Problem The customer reported that the washer doesn’t spin the clothes … Read more
A Tallmadge customer called about their Whirlpool washer’s spin cycle not working, making weird droning noise and thumping like the load was uneven. We found the hub had stripped, causing the wash plate to lose connection and creating the noise and balance issues. The Problem The spin cycle is not working. It makes weird droning … Read more
A customer on Homeland Avenue Northeast in Louisville called about their LG washer that wouldn’t power on. When we opened up the WM5000HVA, we found the main board was getting 120V but the user interface was unresponsive despite having DC voltage. The Problem The washer wouldn’t power on at all. No lights, no response when … Read more
We returned to Massage Envy in Canton, OH for a follow-up repair on their LG washer that was not draining. Our initial inspection revealed multiple issues — a cracked soap dispenser housing was leaking water onto the drain pump, causing it to fail. The Problem The customer reported the same issue as the previous week … Read more
A customer in North Canton called about their LG washer flooding water all over the floor. When we arrived at the home on 7th Street Northeast, we found the washer drum had broken in the front and was leaking extensively onto the floor. The Problem The customer reported that water floods from the washer all … Read more
A customer in Bolivar, OH called about their LG washer making noise during the drain cycle and not draining properly. They suspected the drain pump had failed after pulling the filter and finding 2 buckets of water that had never been there before. Our diagnosis confirmed their suspicion — the drain pump had indeed failed. … Read more
Washer wouldn’t finish cycles due to a clogged cold water inlet screen. Cleaning the screen restored proper fill and the cycle now completes.
Washer would not drain and showed OE error. A failed drain pump and a control board not sending power were replaced to restore proper draining.
This LG washer in Minerva, OH wouldn’t drain water and was making a low rumbling noise like the motor was going bad, then flashing error code PF. When we opened it up, we found the drum support was broken — a major structural failure that made repair uneconomical. The Problem The customer reported their washer … Read more
A Kenmore washer on Edison Street in Alliance, OH was leaking water when it spins out and rumbling loudly while spinning. Our diagnosis revealed the bearings had failed, causing water to leak onto the floor during the spin cycle. The Problem The customer reported their Kenmore washer was leaking water when it spins out and … Read more